ge logiq c3 pro怎么设置中文
作者:百变鹏仔日期:2023-08-07 04:11:15浏览:8分类:文字大全
logiq C3或logiq C3的软件盘(System & Application Software)
Insert the disk labeled “System & Application Software” into the DVD ROM drive.
插入我们上面提到的软件盘到dvd光驱里
Properly turn off the scanner by momentarily pressing the Power On/Off Switch. Select “Shut Down” from the System Exit menu
正常关闭设备开关 然后从弹出的菜单中选择 “Shut Down(关机)”
If the system will not shutdown normally, hold down the Power On/Off Switch until the light turns from green to amber
如果系统不能正常关机 ,请按住电源开关键 大约30秒, 系统会强制关闭 ,指示灯会从绿色变为**。
Turn on the system. System will detect the DVD-RW automatically.
打开机器,机器将会自动选自从DVD-RW运行
Press any key to continue when below message display as shown below.
直到显示器最下方出现“Press any key to continue”字样 说明机器已经读取光驱光盘的内容了,这是能否继续的关键
出现上面内容大家可以按任意键继续
Select one of the options for loading the system. Select choice 1] to load the complete disk.
手册提示选一进行系统安装
这里我说下选1和2的区别
选1一般情况都是我们给机器换新硬盘,或者机器中了病毒 对全盘进行格式化
选2 这种就是针对老机器里面有用户参数和数据的 可以选2 不会破坏数据
接着步骤4我们选一 会看见以下界面
Press any key to continue when below message display as shown below.
下面的消息显示“Press any key to continue”,如下图所示。
接着步骤5我们按任意键,会看见以下界面
System CD will be loaded as shown in the screen below.
如图所示 会出现我们常见的GHOST的界面 这就是系统正在恢复 等待进度条完成
System updating finished,
系统升级完成 就回出现 以下界面 如图
8
Press power key to reboot system, then remove the CDROM from the drive immediately. When system first time boot up after upgrading complete, type Serial Number and Option Key before starting up
重启彩超机器 拿出系统光盘 等待系统启动后 输入序列号和选项密钥
注意:千万要备份好序列号和选项密钥 否则非常麻烦
一、此为消化系超声,包括肝、胆、胰、脾(居然还有肾,蛮全的!),但没有胃,因为胃内是空的、、、
二、看这个东西最重要就是看诊断,就是上面写的“超声提示”。
三、没什么大事,脂肪肝可能是喝酒喝的吧,年轻人控制饮食自然就好了,胆囊炎也只是从B超上看到的,如果没有胆囊炎的症状,也可以不用考虑。
四、最重要的一句是最后一句:
“注:超声提示仅供参考,请结合临床考虑。”
图片声明:本站部分配图来自网络。本站只作为美观性配图使用,无任何非法侵犯第三方意图,一切解释权归图片著作权方,本站不承担任何责任。如有恶意碰瓷者,必当奉陪到底严惩不贷!
- 上一篇:已经是第一篇了
- 下一篇:已经是最后一篇了
猜你还喜欢
- 05-31 人类怎么组词怎么造句?
- 05-31 漂洋该怎么造句?
- 05-31 勇士造句怎么写论文电脑?
- 05-31 不予参与怎么造句?
- 05-30 早怎么造句?
- 05-30 怎么用share造句?
- 05-30 剥皮怎么造句简短?
- 05-30 弯曲怎么组词造句?
- 05-30 什么没怎么造句?
- 05-30 抗议怎么造句?
- 05-30 整齐怎么造句?
- 05-30 并不怎么造句?